Centor series

Start in the left upper corner and click on NEW. Then you can give a name to your profile. Go to the first under profile; click on NEW, enter what you need, and click on SAVE. As long as the parameters in a profile aren’t saved the lines have a red background. Once they are saved they have a blue background. If you have created and saved all three under profiles (the first lines of each profile still have a red background), you click in the left upper corner on SAVE and store the complete profile. You will see that the red lines change into blue.

Up to 10% of its capacity, the sensor can survive off center forces without being damaged. However it is clear how these forces influence force readings in low ranges. The load cell performs best when placed directly in line with the applied force. Pulling straight up or pushing straight down is best for the instrument safety and accuracy y

The external sensor requires an additional SPIP module. It also requires attachments at the top and bottom of the load cell.

The Centor has a 24 bit ADC. The reading from the ADC is divided by 1000 to arrive at a resolution of 1 in 10,000.

You must have COMPUT enabled. You must have run more than one test to calculate statistics. Press the M key. Use the up or down arrow keys to highlight STATS. Press the TDX key. Press the X key do not erase. Press the X key. The statistic values are displayed on the main screen. Press the MAX key until CPI is displayed in the lower right corner. Now press the M key. You will notice STATS are displayed as computed values.